The FXM2IC102 is a configurable dual-voltage-supply translator designed for bi-directional voltage translation over a wide range of input and output voltage levels..

The FXM2IC102 is intended for use as a voltage translator in applications using the I²C bus interface. Input and output voltage levels are compatible with I²C device specification voltage levels.

The device is designed so that the A port tracks the V_CCA level and the B port tracks the V_CCB level. This allows for bi-directional voltage translation over voltage ranges: 1.8V, 2.5V, 3.3V, and 5.0V.

The device remains in 3-state until both V_CCs reach active levels, allowing either V_CC to be powered up first. Internal power-down control circuits place the device in 3-state if either V_CC is removed.

The two ports of the device have auto-direction sense capability. Either port may sense an input signal and transfer it as an output signal to the other port.

Schmitt triggers are used on data inputs for signal noise suppression. Typically the inputs have 100 millivolts of hysteresis over the full V_CC range.

The FXM2IC102 typically consumes only 230nA during “no I²Cdata transactions” when V_CCA = 1.8V and V_CCB = 3.3V.

FXM2IC102 exhibits robust I²C repeater performance due to strong current sinking capability in > 400pf bus segments.

• Bi-Directional Interface between any Two Levels from 1.65V to 5.5V
• Auto-Direction Sensing, Direction Control not Needed
• Buffer Isolates Capacitance and Allows 400pF on Each Port
• Open-Drain Inputs/Outputs
• Schmitt Trigger Data Inputs
• Accommodates Standard-Mode and Fast-Mode I²C-bus Devices
• Fully Configurable: Inputs and Outputs Track V_CCLevel
• Non-Preferential Power-up; Either V_CC May be Powered Up First
• Outputs Remain in 3-State until Active V_CC Level is Reached
• Power-Off High Impedance
• Active HIGH Output Enable Referenced to V_CCA
• 5V Tolerant Output Enable
• Packaged in 8-Terminal Leadless MicroPak™ (1.6mm x 1.6mm)/li>
• ESD protection exceeds:
  
  • 8kV HBM ESD (per JESD22-A114 & Mil Std 883e 3015.7)
  • 15kV HBM I/O to GND ESD (per JESD22-A114 & Mil Std 883e 3015.7)